Wrist Strap, Length:10FT/3M

A corded ESD wrist strap with an adjustable hook-and-loop wrist band, stainless steel snap, and 3 m TPU grounding cord.

The AS-611H is suitable for electronic assembly, semiconductor work, precision equipment repair, and personnel who need to protect electrostatic-sensitive components. Always use it according to the product manual, site conditions, and applicable work procedures.

The adjustable hook-and-loop wrist band and stainless steel snap make it easy to achieve a secure fit and maintain a reliable conductive connection. Correct setup and the specified operating range must still be observed; performance should not be judged from a single feature alone.

The TPU cord protection and approximately 1 MΩ cord resistance improve cable durability and allow static electricity from the body to dissipate to ground in a controlled manner. This design is primarily intended to improve operating efficiency, stability, and ease of on-site interpretation.

Ensure that the conductive surface of the wrist band contacts bare skin, connect the grounding clip to a verified ESD grounding point, and check the strap with a wrist-strap tester before use.

Wrist-band resistance is approximately 10³–10⁵ Ω, cord resistance is 10⁶ Ω, the wrist band is adjustable, and the cord length is approximately 10 ft/3 m.

Do not connect it to a mains live conductor, an unknown equipment enclosure, or an unverified grounding point. It does not replace power isolation or electrical insulation measures.

Clean the wrist band regularly, inspect the hook-and-loop fastener, snap, and cord, and test the system resistance according to the applicable ESD control procedure.

The AS-611H uses an adjustable hook-and-loop design. If you prefer a fixed elastic wrist band, compare it with other corded ESD wrist straps.

Confirm the connector type, cord length, wrist-band size, and workstation grounding requirements, and use it with a wrist-strap tester.