End Pass Through Mini Crimper

It is a network crimping tool that integrates cable cutting, stripping, crimping, and conductor trimming for pass-through connectors and supports both pass-through and standard RJ45 plugs.

The CP-342 is suitable for enterprise and home network cabling, low-voltage engineering, surveillance systems, and installers making RJ45 patch cables. Follow the product manual, site conditions, and operating procedures.

Compatibility with both common RJ45 designs allows one tool to handle pass-through and standard plugs, reducing tool changes. Use correct settings and remain within the applicable range; do not judge results from one function alone.

Vertical crimping distributes force more evenly across the contacts, reducing contact misalignment and incomplete crimps. This design improves operating efficiency and stability.

Arrange the conductors in the required sequence and insert them into a compatible plug. Confirm that every conductor is fully seated, place the plug in the crimping cavity, and squeeze completely until the ratchet releases.

It integrates cutting, stripping, crimping, and trimming and supports pass-through and standard RJ45 connectors. Replacement blades are available through distributors.

The cable-cutting and conductor-trimming blades are sharp. Keep fingers out of the work area, and do not use the tool on energized circuits or unspecified terminals.

Remove wire and plastic debris, apply a small amount of lubricant to moving joints, and replace dull or chipped blades. Do not grind or alter the die yourself.

If pass-through RJ45 connectors are used primarily, the CP-342 can crimp and trim excess conductors in one operation. If 4P/6P telephone connectors are also required, select a multi-format crimper.

Confirm that the connector is RJ45 and whether it is pass-through or standard. Also check whether shielded connectors, replacement blades, or additional wire-gauge functions are required.