Noise-filtering Network PoEToner & Probe Kit

It is an interference-resistant audio cable tracer that performs tracing, wire mapping, switch-port blinking, and connector-crimp checks in PoE-switch and shielded-network environments.

The MT-7029N is suitable for enterprise networks, surveillance, telephone and low-voltage cabling, and technicians locating cables in data centers or complex cable ducts. Follow the product manual, site conditions, and operating procedures.

These functions reduce the effect of high-frequency noise on audio tracing and help locate a target among multiple circuits. Use correct settings and remain within the applicable range; do not judge results from one function alone.

These functions cover common shielded networks and switch-port identification while checking RJ45 termination status. They improve operating efficiency, stability, and field interpretation.

Connect the transmitter to the circuit and select the corresponding mode, then move the receiver along the cable to find the strongest signal. For port blinking, observe the switch indicators.

It supports tracing on PoE networks and STP/SFTP shielded cable, RJ45 wire mapping, port blinking, crimp testing, and NCV non-contact voltage detection.

Confirm the interface and voltage conditions before connecting to an unknown circuit. NCV is only a preliminary check and does not replace formal verification of de-energization.

Keep the RJ45 interfaces and probe clean, avoid pulling cables, humidity, and drops, and remove or inspect the batteries periodically during long-term storage.

The MT-7029N is suitable for interference-resistant tracing and PoE/shielded-cable environments. If cable-length measurement and graphical display are the main requirements, compare the MT-7071N.

Confirm the need for tracing, wire mapping, port blinking, PoE, and shielded-cable functions and check the MT-7029N/MT-7029N-C market version.